You can loosen your skateboard wheels by rotating them anticlockwise. If you find it hard to push or your skateboard comes to a halt automatically, it means you need to loosen them.
Just stand on your skateboard and push for a few minutes. Now, if you are worried about over-tightening your skateboard wheels, I have a solution for that too. Now check again by spinning the wheel with one hand.Once it is done, use an adjustable wrench and finish the tightening.Put the washer and begin tightening the nut in a clockwise motion.Put the wheels on the truck’s axle with the graphics facing inward.After this, insert them into each wheel of your skateboard. Clean your bearings or you can buy new ones.To do this follow the simple steps mentioned below: In case the wheels are unsteady, you need to tighten them so that they can spin without constraint. You can easily check this by flicking the wheel with one hand. There is no set answer to this question, however, make sure that your skateboard wheels are not so loose that they wobble on the truck’s axle. It is a very important question when it comes to skateboarding. Should Skateboard Wheels Be Tight or Loose? So if you agree with me, flip your wheels periodically and I am sure you will be able to see the results yourself. This way, your wheels will last longer and your ride will be smoother. While there is no rule, I will still advise you to flip your skateboard wheels to prevent the wear and tear of wheels while skateboarding. Seeing this, many other skaters followed and now it has become an unsaid rule of the skateboarding world. Some also believe that it prevents the wearing of the wheels. However, few skaters preferred graphics inwards because they thought of it as a distraction. As long as the wheels have the same shape, you can put the graphics outside or inside according to your wish. There is no rule when it comes to which way your skateboard wheels face.
Also, it gives a different look to the skateboard. Moreover, since it is hard for people to find their favorite brand’s wheels without the graphics, they prefer turning them inside. Now there are many other skateboarders who flip their wheels as they find the graphics distracting when performing slides or different stunts.